IRD306 Analog Vibration Meter with 25 mV/mm/sec Velometer

IRD306 Analog Vibration Meter with 25 mV/mm/sec Velometer

IRD306 Analog Vibration Meter can be factory set for different types of Velometers. The velometers supported are:
  1. IRD531 4 mV/mm/sec
  2. IRD531 25 mV/mm/sec
  3. IRD544 42.52 mV/mm/sec
In this article we focus on IRD306 Analog with IRD531 25 mV/mm/sec. The meter is able to measure vibration velocity in mm/sec peak and displacement in microns peak-peak. There is a rotary knob which has the range positions 3, 10, 30, 100, 300, 1000, 3000, Battery Test and OFF. When knob is rotated - the meter display needle first acknowledges the change and then settles to the expected/observed value within the 3 seconds settling time of the sensor and meter. So, please wait for at least 5 seconds after setting toggle switch and range knob to note your readings.

    • Related Articles

    • How to correctly read Vibration on IRD811

      IRD811 is an Analog Display Vibration Meter. It has two scales for two range multiples. If you are reading in the multiple of 10, then you need to refer to the top 0 to 1.0 scale and grade it according to your full scale range selection. If you are ...

    • About IRD306DI

      IRD306DI is a Portable Digital Vibration Meter. It is meant for Vibration Measurement of Large Machinery. It is manufactured by IRD Mechanalysis Limited in Maharashtra in India. It boasts the following features: It works with Sensor IRD544 which is ...

    • Which Input Sensor does IRD301 Vibration Meter use?

      IRD301 Vibration Meter measures Vibration Velocity in mm/sec RMS. It uses an IEPE type Accelerometer of 100 mV/g Sensitivity as its Input Sensor. IRD521 is a 100 mV/g output sensor that is paired with IRD301 in its kit. The mV/g signal is Integrated ...

    • How to use IRD CAL Portable Calibrator?

      IRD CAL Portable Calibrator is an easy to use device that can be used to quickly check Calibration of Vibration Meters on-site. It has Three Switch Positions - OFF, mV/g and mV/mm/s. It has a 2 Pin MS Male Connector and an Indication Lamp for Power ...

    • How to Operate IRD306DP

      IRD306DP is a Digital Vibration Meter that allows for measurement of General Machinery Vibration. It works with the Velometer IRD531. The following steps list the method of operating an IRD306DP. Step 1: Insert two numbers of 9 V Batteries ...