IRD306DI is a Portable Digital Vibration Meter. It is meant for Vibration Measurement of Large Machinery. It is manufactured by IRD Mechanalysis Limited in Maharashtra in India. It boasts the following features:
It works with Sensor IRD544 which is an inductive type velocity output sensor. The Sensor provides an input of 42.52 mV/mm/sec to the meter
It is supplied with a cable which has TNC connector at meter end and 2 Pin MS connector at Sensor end. The cable is of 1.2 meters in length and is rubber insulated and shielded
The meter features a kick stand for convenience and also has the provision to be mounted on the wall for storage.
The meter works on 2 Numbers of 9V Batteries which snap on in the battery compartment via Battery Snappers
The meter has a 3 1/2 Digit LCD Display which provides LOBAT (Low Battery) indication along with Vibration Amplitude Readout
IRD306DI reads Vibration Velocity in mm/sec RMS and Vibration Displacement in microns peak-peak. There is a membrane keypad to select between the two reading modes along with LED indication of the mode selected.
The meter can read a maximum of 200 mm/sec RMS and a maximum of 2000 microns peak-peak
The meter is supplied with spare cable, stinger and magnet for catering to different mounting applications.
ISO: 10816-3 chart is pasted on the face of the meter for easy reference
Introduction to Spike Energy IRD Mechanalysis have developed “Spike Energy” to detect rolling element bearing condition in its very early stage. “Spike Energy” detects low amplitude transient impacts generated within the ultrasonic frequency range by ...
IRD306DP is a Digital Vibration Meter that allows for measurement of General Machinery Vibration. It works with the Velometer IRD531. The following steps list the method of operating an IRD306DP. Step 1: Insert two numbers of 9 V Batteries ...
In order to check the Calibration of IRD306DI with its Sensor IRD544, a Portable Vibration Calibrator or a Permanent Vibration Calibrator is needed. The Calibrator should have the facility to generate a pure vibration of a fixed frequency and a fixed ...
IRD811 is an Analog Display Vibration Meter. It has two scales for two range multiples. If you are reading in the multiple of 10, then you need to refer to the top 0 to 1.0 scale and grade it according to your full scale range selection. If you are ...
When you purchase a IRD306DP Digital Vibration Meter Kit - you receive the following: IRD306DP Vibration Meter - 1 No. IRD531 Vibration Sensor - 1 No. Coiled Cable with TNC Connector - 2 Nos. Stinger - 1 No. Magnetic Base - 1 No. Carry Bag - 1 No. ...